These GROMACS trajectories show the existence of a critical point in deeply supercooled WAIL water. Also included is the code necessary to reproduce the figures in the corresponding paper from these trajectories. From this data the critical temperature, pressure, and density of the model can be found, and critical fluctuations in the deeply supercooled liquid can be directly observed (in a computer-simulation sense).
The growth of magnetic islands in NSTX is modeled successfully, with the consideration of passing fast ions. It is shown that a good quantitative agreement between simulation and experimental measurement can be achieved when the uncompensated cross-field current induced by passing fast ions is included in the island growth model. The fast ion parameters,
along with other equilibrium parameters, are obtained self-consistently using the TRANSP code with the assumptions of the ‘kick’ model (Podestà et al 2017 Plasma Phys. Control. Fusion 59 095008). The results show that fast ions can contribute to overcoming the stabilizing effect of polarization current for magnetic island growth.
Non-axisymmetric magnetic fields arising in a tokamak either by external or internal perturbations can induce complex non-ideal MHD responses in their resonant surfaces while remaining ideally evolved elsewhere. This layer response can be characterized in a linear regime by a single parameter called the inner-layer Delta, which enables outer-layer matching and the prediction of torque balance to non-linear island regimes. Here, we follow strictly one of the most comprehensive analytic treatments including two-fluid and drift MHD effects and keep the fidelity of the formulation by incorporating the numerical method based on the Riccati transformation when quantifying the inner-layer Delta. The proposed scheme reproduces not only the predicted responses in essentially all asymptotic regimes but also with continuous transitions as well as improved accuracies. In particular, the Delta variations across the inertial regimes with viscous or semi-collisional effects have been further resolved, in comparison with additional analytic solutions. The results imply greater shielding of the electromagnetic torque at the layer than what would be expected by earlier work when the viscous or semi-collisional effects can compete against the inertial effects, and also due to the intermediate regulation by kinetic Alfven wave resonances as rotation slows down. These are important features that can alter the nonaxisymmetric plasma responses including the field penetration by external fields or island seeding process in rotating tokamak plasmas.
Liquid metal can create a renewable protective surface on plasma facing components (PFC), with an additional advantage of deuterium pumping and the prospect of tritium extraction if liquid lithium (LL) is used and maintained below 450 C, the temperature above which LL vapor pressure begins to contaminate the plasma. LM can also be utilized as an efficient coolant, driven by the Lorentz force created with the help of the magnetic field in fusion devices. Capillary porous systems can serve as a conduit of LM and simultaneously provide stabilization of the LM flow, protecting against spills into the plasma. Recently a combination of a fast-flowing LM cooling system with a porous plasma facing wall (CPSF) was investigated [Khodak and Maingi (2021)]. The system takes an advantage of a magnetohydrodynamics velocity profile, as well as attractive LM properties to promote efficient heat transfer from the plasma to the LL at low pumping energy cost, relative to the incident heat flux on the PFC. In case of a disruption leading to excessive heat flux from the plasma to the LM PFCs, LL evaporation can stabilize the PFC surface temperature, due to high evaporation heat and apparent vapor shielding. The proposed CPSF was optimized analytically for the conditions of a Fusion Nuclear Science Facility [Kessel et al. (2019)]: 10T toroidal field and 10 MW/m2 peak incident heat flux. Computational fluid dynamics analysis confirmed that a CPSF system with 2.5 mm square channels can pump enough LL so that no additional coolant is needed.
Kiefer, Janik; Brunner, Claudia E.; Hansen, Martin O. L.; Hultmark, Marcus
Abstract:
This data set contains data of a NACA 0021 airfoil as it undergoes upward ramp-type pitching motions at high Reynolds numbers and low Mach numbers. The parametric study covers a wide range of chord Reynolds numbers, reduced frequencies and pitching geometries characterized by varying mean angle and angle amplitude. The data were acquired in the High Reynolds number Test Facility at Princeton University, which is a closed-loop wind tunnel that can be pressurized up to 23 MPa and allowed for variation of the chord Reynolds number over a range of 5.0 × 10^5 ≤ Re_c ≤ 5.5 × 10^6. Data were acquired using 32 pressure taps along the surface of the airfoil. The data are the phase-averaged results of 150 individual half-cycles for any given test case.
This dataset includes information about approximately 6,000 books and other items with bibliographic data as well as summary information about when the item circulated in the Shakespeare and Company lending library and the number of times an item was borrowed or purchased.
The Shakespeare and Company Project: Lending Library Events dataset includes information about approximately 35,000 lending library events including membership activities such as subscriptions, renewals and reimbursements and book-related activities such as borrowing and purchasing. For events related to lending library cards that are available as digital surrogates, IIIF links are provided.
The Shakespeare and Company Project: Lending Library Members dataset includes information about approximately 5,200 members of Sylvia Beach's Shakespeare and Company lending library.
The Shakespeare and Company Project makes three datasets available to download in CSV and JSON formats. The datasets provide information about lending library members; the books that circulated in the lending library; and lending library events, including borrows, purchases, memberships, and renewals. The datasets may be used individually or in combination site URLs are consistent identifiers across all three.
The item included here is a collection of wave profiles collected and presented in the accompanying paper: Rucks, M. J., Winey, J. M., Toyoda, T., Gupta, Y. M., & Duffy, T. S. (in review). "Shock compression of fluorapatite to 120 GPa" Submitted to Journal of Geophysical Research: Planets.
This dataset includes individual CIF files with the refined structure of fluorapatite under compression to 61 GPa. The structures have been discussed in detail in the accompanying manuscript "Single-crystal X-ray diffraction of fluorapatite to 61 GPa"
This archive contains spike trains simultaneously recorded from ganglion cells in the tiger salamander retina with a multi-electrode array while viewing a repeated natural movie clip. These data have been analyzed in previous papers, notably Puchalla et al. Neuron 2005 and Schneidman et al. Nature 2006.
Kraus, B. Frances; Gao, Lan; Hill, K. W.; Bitter, M.; Efthimion, P. C.; Hollinger, R.; Wang, Shoujun; Song, Huanyu; Nedbailo, R.; Rocca, J. J.; Mancini, R. C.; MacDonald, M. J.; Beatty, C. B.; Shepherd, R.
Abstract:
A high-resolution x-ray spectrometer was coupled with an ultrafast x-ray streak camera to produce time-resolved line shape spectra measured from hot, solid-density plasmas. A Bragg crystal was placed near a laser-produced plasma to maximize throughput; alignment tolerances were established by raytracing. The streak camera produced single-shot time-resolved spectra, heavily sloped due to photon time-of-flight differences, with sufficient reproducibility to accumulate photon statistics. The images are time-calibrated by the slope of streaked spectra and dewarped to generate spectra emitted at different times defined at the source. The streaked spectra demonstrate the evolution of spectral shoulders and other features on ps timescales, showing the feasibility of plasma parameter measurements on the rapid timescales necessary to study high-energy-density plasmas.
Hill, K. W.; Gao, L.; Kraus, B. F.; Bitter, M.; Efthimion, P. C.; Pablant, N. A.; Schneider, M. B.; Thorn, D. B.; Chen, H.; Kauffman, R. L.; Liedahl, D. A.; MacDonald, M. J.; MacPhee, A. G.; Scott, H. A.; Stoupin, S.; Doron, R.; Stambulchik, E.; Maron, Y.; Lahmann, B.
Abstract:
Numerical data used to draw the figures in the manuscript
This dataset contains supplementary materials for Chapter 4 and Chapter 5 of Yiheng Tao's PhD dissertation (2022). The dissertation’s abstract is provided here:
Carbon capture, utilization, and storage (CCUS) mitigates climate change by capturing carbon dioxide (CO2) emissions from large point sources, or CO2 from the ambient air, and subsequently reusing the captured CO2 or injecting it into deep geological formations for long-term and secure storage. Almost all current decarbonization pathways include large-scale CCUS, on the order of a billion tonnes (Gt) of CO2 captured and stored each year globally starting in 2030, yet the actual deployment has lagged far behind (around 0.04 Gt CO2 was captured in 2021). In this dissertation, I contribute to several aspects of largescale deployment of CCUS by (1) developing and applying efficient numerical models to simulate geological CO2 storage and (2) identifying key policies to address the bottlenecks of overall CCUS deployment. This dissertation concerns the United States, China, and the Belt and Road Initiative (BRI) region through research projects that are consistent with each location’s current development stage of CCUS.
Chapters 2 and 3 contain computational modeling studies. In Chapter 2, I develop a new series of vertical-equilibrium (VE) models in the dual-continuum modeling framework to simulate CO2 injection and migration in fractured geological formations. Those models are shown to be effective and efficient when properties of the formation allow for the VE assumption. In Chapter 3, I apply a VE model to simulate basin-scale CO2 injection in the Junggar Basin of Northwestern China. The results show that current regional emissions of more than 100 million tonnes of CO2 per year can be stored effectively, thereby confirming the great potential of the Junggar Basin for early CCUS deployment.
Chapters 4 and 5 contain policy analyses. In Chapter 4, I propose a dynamic system consisting of new CO2 pipelines and novel Allam-cycle power plants in the Central United States, and examine how government policies, including an extended Section 45Q tax credit, may improve the economic feasibility of this system. Lastly, in Chapter 5, I investigate and quantify CO2 emissions implications of power plant projects associated with the BRI. I also propose a “greenness ratio” to measure the level of environmental sustainability of BRI in the power sector.
This is the supplemental material for the manuscript "Verification, validation, and results of an approximate model for the stress of a Tokamak toroidal field coil at the inboard midplane" submitted to Fusion Engineering and Design. This material includes PDF writeups of the derivations of the axisymmetric extended plane strain model, the elastic properties smearing model, and 20+ MATLAB scripts and functions which implement the model and generate the figures in the paper.
This entry contains video files and tabular data associated with the PhD dissertation titled: The Evolution and Regulation of Morphological Complexity in the Vibrios.
Kim, Chang-Goo; Ostriker, Eve; Gong, Munan; Kim, Jeong-Gyu
Abstract:
We present the public data release of the TIGRESS (Three-phase Interstellar Medium in Galaxies Resolving Evolution with Star Formation and Supernova Feedback) simulations. This release includes simulations representing the solar neighborhood environment at spatial resolutions of 2 and 4 pc. The original magneto-hydrodynamic simulation data is published along with data products from post-processing, including chemistry, CO emission line, and photoionization (HII regions). Data reading and analysis examples are provided in Python.
In our study, we compare the three dimensional (3D) morphologic characteristics of Earth's first reef-building animals (archaeocyath sponges) with those of modern, photosynthetic corals. Within this repository are the 3D image data products for both groups of animals. The archaeocyath images were produced through serial grinding and imaging with the Grinding, Imaging, and Reconstruction Instrument at Princeton University. The images in this repository are the downsampled data products used in our study, and the full resolution (>2TB) image stacks are available upon request from the author. For the coral image data, the computed tomography (CT) images of all samples are included at full resolution. Also included in this repository are the manual and automated outline coordinates of the archaeocyath and coral branches, which can be directly used for morphological study.
Schwartz, Jacob A.; Nelson, A. O.; Kolemen, Egemen
Abstract:
Shaping a tokamak plasma to have a negative triangularity may allow operation in an ELM-free L-mode regime and with a larger strike-point radius, ameliorating divertor power-handling requirements. However, the shaping has a potential drawback in the form of a lower no-wall ideal beta limit, found using the MHD codes CHEASE and DCON. Using the new fusion systems code FAROES, we construct a steady-state DEMO2 reactor model. This model is essentially zero-dimensional and neglects variations in physical mechanisms like turbulence, confinement, and radiative power limits, which could have a substantial impact on the conclusions deduced herein. Keeping its shape otherwise constant, we alter the triangularity and compute the effects on the levelized cost of energy (LCOE). If the tokamak is limited to a fixed B field, then unless other means to increase performance (such as reduced turbulence, improved current drive efficiency or higher density operation) can be leveraged, a negative-triangularity reactor is strongly disfavored in the model due to lower \beta_N limits at negative triangularity, which leads to tripling of the LCOE. However, if the reactor is constrained by divertor heat fluxes and not by magnet engineering, then a negative-triangularity reactor with higher B0 could be favorable: we find a class of solutions at negative triangularity with lower peak heat flux and lower LCOE than those of the equivalent positive triangularity reactors.
